Datums and the 3-2-1 locating principle

基准与六点定位

Illustration of Datums and the 3-2-1 locating principle
AI-generated sketch: it shows the idea, not exact engineering detail.

In plain words

To measure or machine anything you need a fixed starting point, like the corner of a room. A loose block can slide three ways and turn three ways; rest it on three points, push it against two, then one, and it cannot move at all.

What it is

Datums are the reference faces or axes that dimensions are measured from. A part has six degrees of freedom; three points on a primary face, two on a second and one on a third remove them all, and clamps then hold the part against those points.

Why it matters for products

Datum choice drives setup planning and fixture design, and explains why some features must be cut in the same setup.

Learn first