Hard-to-machine geometry: thin walls, deep pockets, sharp internal corners
薄壁、深腔与内尖角
In plain words
Three shapes that always cost extra: walls as thin as paper (they shake), deep narrow pockets (need long bendy tools), and sharp inside corners (a round cutter cannot make them).
What it is
Internal corners take at least the tool radius, and a radius slightly larger than the tool cuts better. Pockets deeper than about 3–4× tool diameter get slow; thin walls (below roughly 1 mm in metal) vibrate and distort. Truly sharp internal corners need EDM or a design change.
Why it matters for products
Each is a detectable geometric condition with a cost multiplier and a DFM message.