Machine dynamics: acceleration, jerk and look-ahead

加减速、加加速度与前瞻控制

Illustration of Machine dynamics: acceleration, jerk and look-ahead
AI-generated sketch: it shows the idea, not exact engineering detail.

In plain words

A machine is heavy and cannot stop or turn on the spot. Like a car on a twisty road, it has to brake before every corner and speed up again after it, so it only reaches the speed written in the program on long straight stretches. That is why a job full of short moves takes much longer than “distance divided by speed” says.

What it is

An axis cannot change speed at once. Each has a limit on acceleration (commonly a few m/s², up to about 1 g on fast machines) and on jerk, the rate at which acceleration changes. The controller reads ahead in the program and slows before corners and through runs of short moves to stay inside those limits and a set path tolerance. The programmed feed is therefore reached only on long straight moves; on 3D surface finishing or a pocket with many corners the real average feed can be far below it. How smooth the toolpath is (point spacing, arc fitting, tolerance) decides how fast the machine can really flow.

Why it matters for products

Path length divided by programmed feed underestimates cycle time; a time model needs each machine's acceleration and corner behaviour, tuned against measured times, and smoother toolpaths are a CAM optimization target.

Learn first

Opens the way to